An Introduction to Gravity Bongs: The Basics

Have you ever wanted to make your own gravity bong? If so, then you’ve come to the right place! Making your own gravity bong is a great way to get creative and save money. Plus, it’s actually quite easy. All you need are a few simple supplies and a bit of know-how. Keep reading and we’ll show you how it’s done.

What You Need for Your Homemade Gravity Bong

Before getting started, you should gather the necessary supplies. Here is what you will need:

•             A two-liter plastic bottle

•             A large bowl or bucket filled with water (about 3/4 full)

•             A knife or scissors

•             Aluminum foil

Making Your Gravity Bong

Once you have all the supplies, making your homemade gravity bong is easy! Just follow these steps:

Cut off the bottom of the two-liter bottle using the knife or scissors. Discard the bottom piece of plastic. 

Cut out a small hole in the side of the bottle about halfway up from the bottom. This hole should be just big enough for your finger to fit through easily.  

Cover the top edge of your bottle with aluminum foil, making sure that all areas are covered securely so that no smoke can escape through any gaps in the foil. Poke several small holes in one end of this aluminum foil cover using a toothpick or other sharp object. These holes should be just big enough for smoke to pass through but not too big as this will reduce air flow and reduce pressure inside the bottle when needed for use.  

Place your plastic bottle into your bucket or bowl filled with water at an angle so that one end is submerged while still allowing air to enter through its open top end (not covered by aluminum foil). The water level should be low enough that only half of your bottle is submerged while still providing enough pressure inside your homemade gravity bong when needed during use later on.  

Pack some cannabis into your aluminum foil covered top end and light it up while inhaling through mouthpiece located at open top end of bottle (not covered by aluminum foil). Make sure to keep inhaling until all smoke has been drawn inside chamber before removing from water and exhaling out mouthpiece afterwards! 

optional): You may want to add some ice cubes into water chamber before use if desired for smoother hits as well as stronger effects from cannabinoids released during combustion when smoking cannabis flower material (buds).   That’s it—you have now successfully made yourself a homemade gravity bong! Enjoy responsibly!  

Making a homemade gravity bong isn’t hard at all once you have gathered all necessary supplies and know what steps are involved in assembling this device correctly from start finish. With just a few minutes’ time, plus some basic materials like aluminum foil and plastic bottles, anyone can create their own personal smoking device without much hassle or expense involved! Whether used recreationally or medicinally, these homemade devices offer users an excellent way to experience their favorite herbs with fewer toxins than traditional smoking methods might provide due to lack of direct combustion occurring during inhalation process itself—so go ahead give them try today!